Proxim ORiNOCO AP-700 Uživatelský manuál stáhnout pdf (Strana 25)

Installation and Initialization AP-700 User Guide

Initialization

change your adapter setting at any time by clicking the Select Adapter button on the Scan List screen. Note

that the ScanTool Network Adapter Selection screen will not appear if your computer only has one network

adapter installed.

Figure 2-8 Scan List

7. Locate the MAC address of the AP you want to initialize within the Scan List.

NOTE: If your Access Point does not show up in the Scan List, click the Rescan button to update the display. If the

unit still does not appear in the list, see Troubleshooting for suggestions. Note that after rebooting an Access

Point, it may take up to five minutes for the unit to appear in the Scan List.

8. Do one of the following:

• If the AP has been assigned an IP address by a DHCP server on the network, write down the IP address and click

Cancel to close ScanTool. Proceed to the Logging In section for information on how to access the HTTP interface

using this IP address.

• If the AP has not been assigned an IP address (in other words, the unit is using its default IP address,

169.254.128.132), follow these steps to assign it a static IP address that is valid on your network:

a. Highlight the entry for the AP you want to configure.

b. Click the Change button.

The Change screen appears.

Figure 2-9 Scan Tool Change Screen

Set IP Address Type to Static.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 220 221

Žádné komentáře

Proxim ORiNOCO AP-700 Uživatelský manuál Strana 25